Hello Guest it is March 28, 2024, 05:01:47 AM

Author Topic: csmio/ip-a encoder wiring  (Read 2787 times)

0 Members and 1 Guest are viewing this topic.

csmio/ip-a encoder wiring
« on: February 15, 2015, 06:06:32 PM »
I have mr-j3-60a amps (Mitsubishi) and a csmio/ip-a controller. I know that the encoder wire go to the amp input then to the controller from the amp output. I have got the six wires for the  A- ,A+ ,B- , B+, Z- ,Z+ . what I dont understand is where does the +5 volt and ground come from.

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: csmio/ip-a encoder wiring
« Reply #1 on: February 16, 2015, 03:46:48 PM »
You do not need 5v and Gnd, they are there so that you can power an encoder if you have a separate encoder. Your encoder is already powered by the drive. You may need to connect the Gnd to the Gnd of the drives I/O but most likely you will not.
Hood
Re: csmio/ip-a encoder wiring
« Reply #2 on: February 16, 2015, 05:03:12 PM »
Thanks Hood !!!!   Your help is greatly appreciated .