Mach Discussion > Video P*r*o*b*i*n*g
Scanything
ozymax:
I found this program on the Sheetcam website today and I'm wondering if anyone here has used it.
I have managed to get Scanything to work but I can't save any file without purchasing the licence. Before I do that I'd be keen to hear of anyones experience with it.
I have been looking for a template tracing program for awhile now. I have tried and tried to get the copycat addon in Mach3 to work properly but it doesn't. That was a waste of money.
ozymax:
Forgot the link.
http://www.sheetcam.com/Scanything/index
BR549:
You can count on anything that LES at SheetCam produces, WORKS. And he WILL support it.
(;-) TP
RICH:
--- Quote --- have tried and tried to get the copycat addon in Mach3 to work properly but it doesn't. That was a waste of money.
--- End quote ---
Not sure what our doing.
Copycat works....read the manual!
RICH
ozymax:
--- Quote from: RICH on February 14, 2015, 07:38:53 PM ---
--- Quote --- have tried and tried to get the copycat addon in Mach3 to work properly but it doesn't. That was a waste of money.
--- End quote ---
Not sure what our doing.
Copycat works....read the manual!
RICH
--- End quote ---
Rich, I appreciate the work that you put into the manual and I have read it SO many times thinking I'm doing something wrong.
The problem that I wrote about in this topic is what I get every time.
http://www.machsupport.com/forum/index.php/topic,27456.0.html
Here's a small file I did of a rectangular plate with 2x 10mm holes in the lower corners.
When I load that file into Mach3 it wants to cut 2x huge holes that are not even close to where they should be.
This is a little off topic but it's the problem I'm having with Copycat that made me look for other solutions.
Navigation
[0] Message Index
[#] Next page
Go to full version