I am trying to get the spindle speed to show up on the screen and use the spindle speed control within Mach3. It worked before I upgraded.
I upgraded my siegx2 from lpt ports to the csmio/ip-m. I have the standard spindle drive, using ampi stepper drives. All the I/O works fine, steppers move without a problem, probe input works, the index shows on the diagnostic screen, the analog output to the sieg spindle drive works and is linear from 1500 to 4100. So the spindle works fine but the speed does not show and it does not seem to be closed loop.
I have read the manual, followed the instructions from csmio.
Any feedback or questions would be helpful. I have emailed the distributor and the manufacturer on the some other topics but have not received a response so I thought I would try this...
Thanks,
Phill