Author Topic: CNC 6040z-4s The Z-Axis Page up and Page down Control keys are reveresed?  (Read 3168 times)

0 Members and 1 Guest are viewing this topic.

Offline egander1

  • Active Member
  • Posts: 3
    • View Profile
I am setting up a CNC 6040z-4s mill and the controls for the Z-axis stepper motor are reversed.  I went to the config->system hotkeys and selected page up for the Z++ and page down for the Z-- and they are reversed from what they should be.  I can reverse the hot keys assignments by selecting page down for Z++ and page up for Z-- but I am wondering if that is the correct way to correct this.  Is there some other method that this should be corrected.  Thank you.

Offline Overloaded

  • Global Moderator
  • *
  • Posts: 4,777
    • View Profile
Re: CNC 6040z-4s The Z-Axis Page up and Page down Control keys are reveresed?
« Reply #1 on: February 13, 2015, 08:28:51 PM »
Page Up for Z++ would be correct for the key.
If the Z goes DOWN when you hit this key, you can reverse the direction of travel buy changing the Active State of the Dir. pin.

Offline egander1

  • Active Member
  • Posts: 3
    • View Profile
Re: CNC 6040z-4s The Z-Axis Page up and Page down Control keys are reveresed?
« Reply #2 on: February 16, 2015, 12:01:58 PM »
Thank you, changing the active state of the directional pin did the trick.