Hello chaps
I am doing a bit of coding with parameters and having trouble getting mach3 to read them
I think it is a syntax error.
firstly -do the normal operators ("+","-","/","*') work on parms??
secondly what about boolean ?
What about "<" and ">" (smaller than and bigger than)
thirdly where do the brackets go?
this is one of the lines i am not getting
Plain english says #5 is equal to #3 minus 2 mm
coded as follows #5=#3-2 doesnt work ??
please help the manual is very brief on this subject is there ant other literature?
regards
fred