Hello Guest it is November 30, 2021, 03:26:00 AM

Author Topic: coil winder spindle control  (Read 1759 times)

0 Members and 1 Guest are viewing this topic.

coil winder spindle control
« on: January 12, 2015, 07:24:10 AM »
I have built small coil winding machine whose wire guide is controlled using x,y and z axis of mach3. The spindle is servo motor controlled on A axis. While winding my g code goes like,

G0 A0Y0
G0A30Y10       layer 1
G0A60Y0          layer 2
G0A90Y10       layer 3
G0A120Y0       layer 4
and so on.
 The problem is at every end spindle stops with defined accn and dccn time which is very time consuming.

How can I continuously run the spindle without stopping at the end of every layer?

pl help.

Offline Tweakie.CNC

  • *
  •  8,863 8,863
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: coil winder spindle control
« Reply #1 on: January 12, 2015, 12:02:40 PM »
I think your best bet is to increase the Acceleration settings in Motor Tuning.. If you need a slow start then make your first move a G01 at a lesser feed rate.


Offline Hood

  •  25,838 25,838
  • Carnoustie, Scotland
    • View Profile
Re: coil winder spindle control
« Reply #2 on: January 12, 2015, 02:24:18 PM »
Are you in Exact Stop mode?
On the coil winder I did the spindle doesnt stop, in fact it hardly slows, I use CV mode.