Author Topic: [Bug?] Keyway Slot operation not using calculated feed speed on non-plunge moves  (Read 1670 times)

0 Members and 1 Guest are viewing this topic.

Offline Analias

  • Active Member
  • Posts: 110
    • View Profile
Mill Wizard 1.0.17 [licensed]

I have a job that uses the Keyway Slot operation.  The generated g-code only specifies the feed speed (F) when plunging and does not override the feed when executing horizontal moves.


-Freeman

I'm not a complete idiot...
    there are some parts missing.

Offline Ron Ginger

  • Active Member
  • Posts: 921
    • View Profile
I think I already fixed that in the version Im working on now, but I will check. I am getting close to anew version that is going to have polygons and polylines, including full pocketing. Its very nice, but I have a couple interface issues we dont like to fix. Maybe out in a week or two.