Hello Guest it is March 29, 2024, 04:08:09 AM

Author Topic: Hesitates with tabs in profile toolpath  (Read 5934 times)

0 Members and 1 Guest are viewing this topic.

Offline P_D_B

*
  •  35 35
    • View Profile
Re: Hesitates with tabs in profile toolpath
« Reply #10 on: December 29, 2013, 08:29:28 AM »
To add one more complexity to this.... I have found that the hesitation as previously discussed was between the G1 and G2 transition; however, it only does it when moving clockwise (looking down at the part).  Counter-clockwise works fine. 
------------------------------------------------------------
Remember Einstein said this...."We can't solve problems by using the same kind of thinking we used when we created them."
__________________________________

Pete

Offline P_D_B

*
  •  35 35
    • View Profile
Re: Hesitates with tabs in profile toolpath
« Reply #11 on: November 02, 2014, 02:17:37 PM »
The finding was and is related to the Stop CV on angles >....

For some reason it only affects cutting in the direction I spoke of before.  I changed it to 180 and the problem went away with the tabs on circles.
------------------------------------------------------------
Remember Einstein said this...."We can't solve problems by using the same kind of thinking we used when we created them."
__________________________________

Pete