Author Topic: Mastercam post processor for mach3  (Read 1260 times)

0 Members and 1 Guest are viewing this topic.

Offline Jmorris

  • Active Member
  • Posts: 13
    • View Profile
Mastercam post processor for mach3
« on: October 04, 2014, 03:58:00 PM »
I am running Mastercam 9.0  and using the MPFAN.pst the table display in mach3 looks correct but the program does not run.

Same program posted using MasterCam_MACH3B.pst the table display is nothing like the subject drafted in Mastercam.  I also tried one other .pst _MACH3LA.pst and it only generates 3 lines of code.

What are others using with success or can you think of something I am doing wrong?

Offline ostie01

  • Active Member
  • Posts: 637
    • View Profile
Re: Mastercam post processor for mach3
« Reply #1 on: October 07, 2014, 03:06:47 AM »
Any Fanuc post should do it

Jeff