Hello Guest it is September 25, 2023, 01:13:30 PM

Author Topic: z axis sometime moves the wrong way  (Read 1735 times)

0 Members and 1 Guest are viewing this topic.

z axis sometime moves the wrong way
« on: September 22, 2014, 12:04:38 PM »
my z axis moves the wrong way sometimes.  x and y are ok

It happens in a program and when I use the manual pendent on the screen.

I mouse click in the arrow u it goes down I mouse click on it again it goes up.

I'm not sure were to look I have checked for loose wires but no luck so far.

Thanks ,john

Offline Hood

  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: z axis sometime moves the wrong way
« Reply #1 on: September 28, 2014, 02:37:19 PM »
Sounds like a Dir wire not making correct contact or possibly a fault in the hardware.
You say however you can not find a loose wire so if you attach your xml I will have a look through that to see if I can find an issue with your Mach config.