Hello Chaps.

Mach turn on o lathe

I recently fitted an inverter and now i have the ability to use css.
please tell me

1. do i use G95 as a word in the initialization string that appears in the general config box?

2. before i B*******R something would you please give me some suggested "safe" settings to start off
with. I use mm mode. please suggest a safe feed rate say f
I tried f 0.05 but it doesnt do anything
3. and how go i apply the CSS in the program.
many thanks

F0.05 usually means 0.05 millimetres per minute. I guess you might not see much happening!
If it is meant to be feed per rev, then maybe you have 50 microns per rev. Ditto.

Cheers

sorry my typo-- should read 0.5
regards