Hello Hood,
I just wanted to thank you for taking the time to assist me with my problem getting Mach 3 set up to properly communicate with our new CNC Router.
You were right, the "shuttlepro"file was for our wireless hand-held controller. We also found the "NcusbPod" file in the plugin and selected it but we are still DEAD (CNC machine not responding).
Here's the latest update.
When we didn't select the "NcusbPod" file, the hand held controller would communicate with the Mach 3 control screen (move the dials, X,Y,Z, feed rates, etc. on the hand-held and the numbers change on the Mach 3 screen). HOWEVER, if we select the "NCusbPod" as the motion control device, (it shows up in the driver window adjacent tothe RED RESET button) but the RED RESET ESTOP button blinks, and the hand-held ceases to communicate with the Mach 3 screen. If we click the blinking RED RESET button, the "NCusbPod" drops out of the Driver window immediately, leaving it empty on the Mach 3 control screen.
Either way (with our without the NcusbPod selected, the CNC Machine is not responding to Mach 3). ANY OTHER GUIDANCE?? We are so frustrated!
Thanks again!