Hello Guest it is November 18, 2019, 05:55:21 AM

Author Topic: SCALE PROBLEMS  (Read 1806 times)

0 Members and 1 Guest are viewing this topic.

SCALE PROBLEMS
« on: July 18, 2014, 12:57:30 PM »
Just bought a new T3020 (chinese) machine and configured it according to the manual. Unfortunately it is cutting about double the size of my uploaded design. The scale is on 1.0000 and in inches which is the format I design in. Tried playing around with the axis calibration but to no avail. Broke three bits already because of too deep Z profiling. I need help please.  >:( ???

Online Tweakie.CNC

*
  • *
  •  8,002 8,002
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: SCALE PROBLEMS
« Reply #1 on: July 19, 2014, 07:40:08 AM »
Hi Marlondave,

Welcome to the forum.

Just take it one step at a time...

In the MDI screen if you Zero the X axis then enter G1 X10 does the axis move exactly 10 units ? (repeat for each axis).
If it does not then your steps per unit are wrong (check forum members documents for how to calculate steps per unit).

Report back on the results then we can move on to the next stage  ;)

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Re: SCALE PROBLEMS
« Reply #2 on: July 20, 2014, 03:02:27 PM »
Tweakie, I did like you said, but I went straight to the mach 3 manual to check on the axis calibration. After some tweaking (paradox eh?), I've been able to tune the motors to the right steps, velocity and acceleration I think is suitable for my machine. I'm now up and running with big  :) :)

Thanks a lot, Tweakie  ;D