Hello Guest it is June 06, 2023, 05:39:58 AM

Author Topic: Mastercam X Lathe Question  (Read 4577 times)

0 Members and 1 Guest are viewing this topic.

Mastercam X Lathe Question
« on: December 30, 2007, 02:12:51 PM »
I just got a Wabeco lathe, and i'm playing around with mastercam X Lathe.
Weird thing: backplotting seems to work properly... see new-1
but when i simulate the machining, it offsets the tool and destroys my part. new-2 shows the program after one pass.

Re: Mastercam X Lathe Question
« Reply #1 on: July 25, 2014, 12:45:27 PM »
Sadly so far I have not been able to use not even a single of the G-Codes generated by Master-cam, it is most that obvious that when I run all my tool paths in the simulation on the computer with master cam every thing works perfectly! but when ever I transfer those G-Codes to my late computer! all hell brake loose! if you have any kind of success please share it with us! I hope that I can hear soon from some one here!