Hello Guest it is November 15, 2019, 09:27:10 PM

Author Topic: new to cnc  (Read 1930 times)

0 Members and 1 Guest are viewing this topic.

new to cnc
« on: June 20, 2014, 02:51:22 PM »
will Mach3 work with a HOBBYCNC control board hardware which use 205 oz stepper motors ?

Offline Tweakie.CNC

*
  • *
  •  7,997 7,997
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: new to cnc
« Reply #1 on: June 21, 2014, 06:28:33 AM »
Yes it will but, as you are probably aware, it requires unipolar stepper motors (5,6 or 8 wire) to be used.

More details here http://www.hobbycnc.com/products/hobbycnc-ez-driver-board-kit/

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Re: new to cnc
« Reply #2 on: June 21, 2014, 11:12:03 AM »
Thank you very much . I have the the board and stepper motors and they are unipolor.

Offline Tweakie.CNC

*
  • *
  •  7,997 7,997
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: new to cnc
« Reply #3 on: June 21, 2014, 11:22:59 AM »
The download link for Mach3 is here http://www.machsupport.com/software/downloads-updates/ please read the manuals, try it out and make sure it meets your requirements before purchasing the license.
Good fortune with your project.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.