Hello Guest it is March 29, 2024, 05:53:21 AM

Author Topic: phase converter error when I stop spindle <<HELP  (Read 2594 times)

0 Members and 1 Guest are viewing this topic.

Offline Learn

*
  •  75 75
    • View Profile
phase converter error when I stop spindle <<HELP
« on: May 17, 2014, 08:06:18 AM »
If I am doing manual work and I shut off the spindle the phase converter errors out making me go behind the machine and hit the rest button . ??? not sure if this was an issue with the old owner as he had a different converter on it . long story short the old owner switched it to a single phase so I could run it in my garage )

any and all help is greatly appreciated
Re: phase converter error when I stop spindle <<HELP
« Reply #1 on: May 17, 2014, 06:11:27 PM »
Most VFDs show an error code an the manual will tell you what the error code means. If your spindle slows down real fast it may be regenerating and cause an over voltage condition if it doesn't have a braking resistor.  That can be fixed by reducing the deceleration rate.

Offline Learn

*
  •  75 75
    • View Profile
Re: phase converter error when I stop spindle <<HELP
« Reply #2 on: May 17, 2014, 09:32:51 PM »
Thanks

Offline Learn

*
  •  75 75
    • View Profile
Re: phase converter error when I stop spindle <<HELP
« Reply #3 on: May 19, 2014, 04:52:07 AM »
I think I figured it out. I think it was my pulley configuration .

Offline Learn

*
  •  75 75
    • View Profile
Re: phase converter error when I stop spindle <<HELP
« Reply #4 on: May 22, 2014, 05:13:18 AM »
I will have to adjust after all . Fail