Hello Guest it is September 26, 2023, 11:59:02 PM

Author Topic: Need help ASAP  (Read 1596 times)

0 Members and 1 Guest are viewing this topic.

Need help ASAP
« on: March 19, 2014, 12:41:35 PM »
here goes
 I setup a job so center is in the middle of the wood. when I start and run the job it starts out ok for the 1st pass but when it gest to the 2nd pass it has move's
 over to the right little by little on each pass I am running mach 3 any help if I need to reinstall the program or just reconfigure my mach3 I just don't know how this happen it was working just fine a week before and I did nothing just turn on the computer. As you can see in the photo's that they both mover over to the right every time. My machine is a KL6090
« Last Edit: March 19, 2014, 12:44:35 PM by DJNPHOTO »

Offline Hood

  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Need help ASAP
« Reply #1 on: March 19, 2014, 03:54:09 PM »
Check the axes are not dirty and thus binding a bit as that is a classic symptom of losing steps.