Hmmm, You are correct, the Z was at 75 when I loaded the XML file. I am sure of this because I noted each axis and wrote it down just before I replied with the XML in my last post. Now comes the strange part. After I saw your reply I ran down and fired up the mill PC and was surprised I did not get the error. Once booted up I checked the velocities for each axis and the Z axis is now at 57. I did not change it and if I had now written it down 30 minutes ago I would doubt what I saw. Very strange. All I can think of is that at some point in checking and downloading the XML I did load a different profile but not sure if it was before or after documenting the settings. I really appreciate you guys helping.