Hello Guest it is April 16, 2024, 02:13:51 PM
Profile Guest
« previous next »
Pages: 1   Go Down

Author Topic: different pitches of axis  (Read 2086 times)

0 Members and 1 Guest are viewing this topic.

Offline skipper

*
  • 36 36
    • View Profile
different pitches of axis
« on: March 11, 2014, 01:16:36 AM »
Hi All,

I have a general question.  Can you configure Mach3 to have three different ball screw sizes?  Can one be metric and one axis be standard units?

Thanks,
skipper
Logged

Offline RICH

*
  • *
  • 7,427 7,427
    • View Profile
Re: different pitches of axis
« Reply #1 on: March 11, 2014, 06:43:49 AM »
Yes you can have different ball screw sizes. In motor tuning, the steps per unit, accounts for different screws since they are calculated values.
You must however only configure Mach for Imperial or Metric. 

RICH
Logged
Pages: 1   Go Up
« previous next »