I upgraded my system and had to add a Smoothstepper. The odd issue I have encountered is the safe Z. When you start the G-code or even when the code stops for a tool change, and you hit start, the Z rapids to the safe Z height, then it travels down at a feed rate to Z-zero, then rapids to the Z height set in the 1st line of code . I have tried all different settings and can not get it to not do that initial move before the G-code.. I know it should go to safe Z then down to the clearance height set in the G-code, mine is usually .25, but it shouldn't go to z-zero.Am I missing something.
Thanks,
Richard