Hello Guest it is January 24, 2025, 07:46:05 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Aspire software  (Read 24646 times)

0 Members and 1 Guest are viewing this topic.

Offline ger21

*
  • *
  • 6,295 6,295
    • The CNC Woodworker
Re: Aspire software
« Reply #10 on: January 28, 2014, 01:55:15 PM »
In Mach3, in General Config, you need to configure tool changes to "Stop Spindle, Wait for Cycle Start".
Logged
Gerry

2010 Screenset
http://www.thecncwoodworker.com/2010.html

JointCAM Dovetail and Box Joint software
http://www.g-forcecnc.com/jointcam.html
Pages: « 1 2   Go Up
« previous next »