Hello
Guest
it is
November 04, 2024, 07:13:14 PM
Guest
Login
Register
Menu
Home
Help
Search
Login
Register
YouTube
Machsupport Forum
/
Mach Discussion
/
General Mach Discussion
/
Motors Not Turning But Are On
« previous
next »
Print
Pages:
«
1
2
Go Down
Author
Topic: Motors Not Turning But Are On (Read 4398 times)
0 Members and 1 Guest are viewing this topic.
dcjohnss
16
Re: Motors Not Turning But Are On
«
Reply #10 on:
July 13, 2020, 02:37:53 AM »
I checked the jumpers on the C11G board but maybe I got them wrong on the ESS itself? That's the last thing I didn't really check that I can think of atm.
Logged
TPS
2,528
Re: Motors Not Turning But Are On
«
Reply #11 on:
July 13, 2020, 02:41:37 AM »
have you set the enable on the c11g?
Logged
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
dcjohnss
16
Re: Motors Not Turning But Are On
«
Reply #12 on:
July 13, 2020, 02:46:48 AM »
Quote from: TPS on July 13, 2020, 02:41:37 AM
have you set the enable on the c11g?
I'm a little confused by that diagram. Are you referring to the jumper by the 5v input? If so that's currently set to ground...
Sorry again for my ignorance. As you can tell I'm quite new at this.
Logged
dcjohnss
16
Re: Motors Not Turning But Are On
«
Reply #13 on:
July 13, 2020, 02:53:59 AM »
If you're asking if I put a 5v power supply there, I did. The red wire goes to the +5v, a second wire goes from the +5v to the enable, and the black wire goes to the ground.
Logged
TPS
2,528
Re: Motors Not Turning But Are On
«
Reply #14 on:
July 13, 2020, 03:07:19 AM »
the 5v supply Need to go to the power terminals.
the enable Needs to be bridged with a wire like on the Picture or has to be supplied by macropump.
all this is explained inthe Manual:
http://cnc4pc.com/Tech_Docs/C11G-R9_USER_MANUAL.pdf
Logged
anything is possible, just try to do it.
if you find some mistakes, in my bad bavarian english,they are yours.
dcjohnss
16
Re: Motors Not Turning But Are On
«
Reply #15 on:
July 13, 2020, 10:22:48 AM »
Yeah, I wired it as shown on this page (obviously with different drivers and motors).
https://www.ebay.com/itm/6-Axis-USB-MOTION-CONTROLLER-UC100-for-Mach3-with-Relay-and-Spindle-Control-C11G-/163811326503
Logged
Print
Pages:
«
1
2
Go Up
« previous
next »