Hello Guest it is November 17, 2019, 08:27:02 PM

Author Topic: Mach3 CRP4848 Setup Help Needed!  (Read 1471 times)

0 Members and 1 Guest are viewing this topic.

Mach3 CRP4848 Setup Help Needed!
« on: January 05, 2014, 09:27:53 PM »
Hi Everyone!

I have assembled a CNC Router Parts CRP4848 over the last few months, and am having problems getting it running.  I can't seem to get the pre-wired Nema 23/G540 electronics to communicate with the Computer/Mach3.  Does anyone else use this system?  I was trying to make it work using Windows 7 32 Bit with a Rosewill PCI card added.  I have since switched to an older computer that uses Windows XP with an on board Parallel Port.  If anyone has any advice, Ports/Pins Configurations, or helpful tips, I would really appreciate it!      

Thanks,

Shaun

Offline Tweakie.CNC

*
  • *
  •  8,000 8,000
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: Mach3 CRP4848 Setup Help Needed!
« Reply #1 on: January 06, 2014, 11:24:51 AM »
Check through all the information here to make sure your configuration is correct (including the BIOS settings). http://www.geckodrive.com/geckodrive-step-motor-drives/g540.html

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.