Hello Guest it is February 22, 2020, 04:53:46 AM

Author Topic: Zero tool height.  (Read 15055 times)

0 Members and 1 Guest are viewing this topic.

Offline Eli

*
  •  13 13
    • View Profile
Re: Zero tool height.
« Reply #30 on: March 31, 2014, 06:02:32 PM »
thank you for your concern and advise. I will send you pictures of where i am at this point. The G540 has 4 inputs, 3 are taken with NC limit switches and the last in put is being used to set the Zero which is NO until the bit touches the copper coin and sets my only open number which is 12. I'll send pictures to make things clearer.Eli