Hello,
I have noticed a problem after I use run from here. I was making an Acrylic tooling plate. The program was stopped to clear the tap drill from melted chips. Then when I went to use Run From Here I received the message stating preparing to move (normal). The Z then starts to raise. I assume this is to clear my .4" clearance or got to the 1" tool start height set by the CAM. The Z will raise to the point of the running out of travel.
I'm using a drill chuck and standard length drill bit which makes the head stock much higher then with other tools. I don't have this problem with shorter tools. I would guess that there is an option or value on how far to Z up.
Any thoughts?
XML attached.
Thank you and Merry Christmas.