Hello Guest it is November 15, 2019, 05:00:49 AM

Author Topic: Mach3 with Vision Router  (Read 1701 times)

0 Members and 1 Guest are viewing this topic.

Mach3 with Vision Router
« on: December 07, 2013, 04:46:51 PM »
There's not a whole lot of information out there on this.

I've acquired a Vision 2448 router / engraver.  It's got a proprietary control panel setup (series II, with serial connection) which doesn't seem to be friendly to anything other than their own software, which doesn't seem to be really useful for what I want to do with it, which is 3D stuff.

Anyway.  The controller has a 25-pin connector to the table, and separate cables heading to the spindles.  Anyone ever tried to figure out the pin outs for the table on a Vision router to drive the table with Mach3?