if I edit the but on in your probing wizard. is there a way to call the same code twice and print or use the average?
OK, here are some steps to get you started in trying this out...
The probe op results are shown by MSM in the probing panel. The circle routines display X and Y (center position) as well as X,Y width and diameter (X,Y = diam for a circle, different for a rectangular pocket).
I'd do the following manually to see if you get the results you want - then you can code up a button.
For a first step you can do one op, get the values, do the 2nd op and compute. The DROs are also accessible from a mach script, so the button code could become a wrapper - it would do one op (make the call the button already does), get the dro values for the result, rotate the spindle, make the probe op call again, get the values, crunch numbers and away you go.
BTW- the primary support forums for MSM are here:
www.CalypsoVentures.com/forumsDave