Hello Guest it is August 08, 2020, 08:50:06 AM

Author Topic: ports and pins  (Read 1443 times)

0 Members and 1 Guest are viewing this topic.

ports and pins
« on: September 28, 2013, 01:59:59 PM »
I'm trying to use the CW spindle relay as dry contact for my spindle enable. output #6 port 2, pin14. Contacts don't close when spindle FWD is pressed. Output #6 changes state. Is there some setting I am missing or is this not possible. I would also like to use CCW like R2-R9
Re: ports and pins
« Reply #1 on: September 28, 2013, 02:33:42 PM »
forgot to say that I am using I06 breakout board