Hello Guest it is March 29, 2024, 06:45:31 AM

Author Topic: Y axis won't move in Job Step but work fine in Continous Mode?  (Read 9573 times)

0 Members and 1 Guest are viewing this topic.

Re: Y axis won't move in Job Step but work fine in Continous Mode?
« Reply #20 on: September 21, 2013, 06:04:56 PM »
Just to confirm: my xml is weird and by recreating it from scratch might fix it?

Offline Hood

*
  •  25,835 25,835
  • Carnoustie, Scotland
    • View Profile
Re: Y axis won't move in Job Step but work fine in Continous Mode?
« Reply #21 on: September 21, 2013, 07:41:40 PM »
Better wait until you see if it works for you :)

Hood
Re: Y axis won't move in Job Step but work fine in Continous Mode?
« Reply #22 on: September 26, 2013, 07:04:08 PM »
I figured it out!!!! It was in Ports and Pins. I needed to tick Step Low Active in the Y-axis. Bingo.