Hello Guest it is March 28, 2024, 10:16:20 AM

Author Topic: Help about Mill option settings  (Read 1782 times)

0 Members and 1 Guest are viewing this topic.

Help about Mill option settings
« on: September 16, 2013, 04:35:00 PM »
Hi,

I'm writing on MachProfile, to add a print option. To do that, I need to know the parameter names of the XML file. On the Config ->Ports Pins "Mill Option" page I couldn't figure out the names for the following checkboxes:
Z-Inhibit On
Persistant
Allow Servo hold on Input#1
Homes true when no home Switches

If some could send me a XML file, where these boxes are checked.
You can find my Email address in my Forum profile

Klaus
The brain isn't a soap, it doesn't shrink when used.