Author Topic: HiCON Integra 7766 Install in Quad-Z Axis Router Table  (Read 16547 times)

0 Members and 1 Guest are viewing this topic.

Online Tweakie.CNC

  • Global Moderator
  • *
  • Posts: 7,678
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: HiCON Integra 7766 Install in Quad-Z Axis Router Table
« Reply #10 on: September 06, 2013, 05:50:46 AM »
Excellent work, excellent write-up on your progress and thank you for sharing all the information.

Tweakie.
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.

Offline alfaalfa

  • Active Member
  • Posts: 33
    • View Profile
Re: HiCON Integra 7766 Install in Quad-Z Axis Router Table
« Reply #11 on: September 08, 2013, 03:41:25 PM »
Hi! Thank you for sharing this project with us!
Until now there's surprisingly few discussions about HiCON/Integra in here. Maybe most integrations have been as easy as ours (see our thread HiCON/Kuhlmann and some videos on Youtube).
After using Vital Systems dspMC/IP since 2008 and now the new HiCON I must highlight how reliable they are in production when comparing to the first Mach tweaks... We have now close to 4000 production hours with one of the very first dspMC/IP controllers here!!
Our next cas will be old CNC lathe where Bosch Alpha 2 was used to control 2 pcs 20 Nm DC servo's and sturdy 16 kW spindle motor (servo).
This is clearly a case for dspMC/IP as the control is classic +-10V.

Terveisin,
Arto