Hello Guest it is May 22, 2019, 01:18:17 PM

Author Topic: Fixture offsets not saved  (Read 975 times)

0 Members and 1 Guest are viewing this topic.

Offline mvoros

*
  •  141 141
    • View Profile
Fixture offsets not saved
« on: August 18, 2013, 10:35:31 AM »
Hi,
I installed Mach R3.043.057 and for some reason it doesn't save the work offsets. When closing Mach, it ask if I want to save the fixture offsets, I say yes to it. But when I start up again the offset values are not there on the Offset page ether. I had the same issue with 3 other versions of mach. I'm using the ESS board. Any ideas?
Mike