Hello:

Newbie here... can someone help me with signal definitions - else point me to a place in some documentation...?

X Home
X ++
X --
EStop
Limit Ovrd

I used the .XLM config file on this site for the MAXNC CL, but I found out too late that the config didn't assign the stop/limit switches - so I broke something... 

I suppose I need to assign the X, Y, and Z limnit switches to something... but what signal to they belong?

Thanks for the help.
-charlie

Hi, Charlie

There is a Mach3 manual that explains all of this, above, Tutorials, Documentations.

This will take you there, http://www.machsupport.com/documentation/M3M1_84-A2.pdf

Hope this Helps, Chip

Thanks for the help Chris, printing it now.
-charlie