Hello Guest it is December 08, 2019, 08:55:30 PM

Author Topic: Homming issue  (Read 1535 times)

0 Members and 1 Guest are viewing this topic.

Offline rhys

*
  •  10 10
    • View Profile
Homming issue
« on: August 15, 2013, 07:38:52 AM »
Hello All,
I am having a homing issue and looking for a little advice. I am using Mach3 to run my homemade CNC router. This machine has four motors, one for X one for Z and two for the Y direction...Y and A. I have slaved the A motor with the Y and it works just fine while running BUT when i home the Y,  that is the only motor that homes, A does not move and as you may see it causes my machine to become out of square.

any help would be appreciated

thank you
john

Offline Hood

*
  •  25,856 25,856
  • Carnoustie, Scotland
    • View Profile
Re: Homming issue
« Reply #1 on: August 18, 2013, 04:38:30 AM »
On General Config page there is an option for homing slave with Master.
Hood

Offline rhys

*
  •  10 10
    • View Profile
Re: Homming issue
« Reply #2 on: August 18, 2013, 07:51:38 AM »
thank you Hood......Its working now.
John