I wonder if you could help me about using DMC-1832 Or DMC-1842 with Mach3 and configure MPG unit attached with system and the motors type are servo motors with (A+,A-,B+,B-,C+,C-) encoders will connect to controller.
Note: the old controller DMC-9542 , I am planing to use DMC-1842 because the old one not support the Galil plugin and not compatible with Mach3.
The most important question I want to know , If I will use DMC-1832 in this machine , I will need any special coding ?
OR I will use Galil plugin to configure this system with Mach3 without needing any coding ??