If anyone can help me with a motor surging not feeding smooth on the x axis of plasma I could paypal $1.00 per min. I just got this machine, it was running smooth until I took it apart to paint, after I reassembled it I had to reprogram motor tuning and steep per inch on all axis’s but one axis is surging at around 60IPM and getting very hot, I can’t seem to get it to go away with any combination of motor tuning parameters I saw phone support but could use help now and I have never used mach before, I am tired of reading about a system I am not familiar with Thanks Chris 850-238-6483
Motor is getting very hot sitting idle with no input

bwahahaha I had the motors plugged in the wrong axis on the computer they are the same size but are diffirent amp says the guy, I think I will go to bed now, to much paint in the brain