Hello Guest it is November 22, 2019, 05:47:54 AM

Author Topic: return from sub  (Read 2264 times)

0 Members and 1 Guest are viewing this topic.

Re: return from sub
« Reply #10 on: April 18, 2015, 03:33:58 PM »
because without some conditional jump....the entire program becomes a called sub-routine.....that works but its a fairly ugly approach......and I'm not impressed with $159 cost if it doesn't do what I would expect....and I never use steppers.....and unless I was brain dead I wouldn't use a parallel port as a control point. And there are many CNC controllers out there....I personally wouldn't spec this one for a project.
bob

Offline BR549

*
  •  6,916 6,916
    • View Profile
Re: return from sub
« Reply #11 on: April 18, 2015, 06:21:18 PM »
10s of thousands of users would tend to disagree.

Have a good day, (;-) TP

Offline RICH

*
  • *
  •  7,371 7,371
    • View Profile
Re: return from sub
« Reply #12 on: April 18, 2015, 08:48:37 PM »
bob,
Guess Mach3 is not for you. Respect your opinion,but, really disagree.

I hope you find a better controller for less and more applicable for all your CNC needs.

I certainly would be interested in what you would recommend along with your constructive evaluation of why it is better.

Till Then,

RICH