Hello Guest it is March 28, 2024, 09:29:48 PM

Author Topic: Mirror  (Read 3474 times)

0 Members and 1 Guest are viewing this topic.

Mirror
« on: February 20, 2007, 11:50:54 AM »
Hi Everyone,

   New user here and I"m missing something and can't find it. When using my milling machine
the text that is being engraved is being cut from right to left, I would like it to be left to right.
Can anyone give me a clue how to make this happen? I really appreciate your help.

I found the problem, I check for past postings about the same problem and found I needed to
go to config/ports & pins/motor outputs/Dir low active for x axis and check for opposite of what
is was.

Thanks
Geo
« Last Edit: February 20, 2007, 12:30:47 PM by wishmasterg »

Offline Chip

*
  • *
  •  2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: Mirror
« Reply #1 on: February 20, 2007, 12:42:47 PM »
Hi,, Geo

On the main screen next to Axis Pos Display, "Scale" click on the +1.0000 display, Enter -1.0 hit Enter key, this will flip your Axis.

Hope this Helps, Chip
Re: Mirror
« Reply #2 on: February 20, 2007, 01:02:29 PM »
Hey Chip,

   Thanks for the reply, I have the axis going the right direction now.
 I see its going to take time to learn all this.

Thanks again
Geo
Re: Mirror
« Reply #3 on: February 23, 2007, 10:29:07 AM »
To change the direction of the axis in the setup of the machine use the Homing and Limits Revers Axis setting.
Fixing problems one post at a time ;)

www.newfangledsolutions.com
www.machsupport.com