Hello Guest it is July 22, 2019, 05:21:33 PM

Author Topic: need help with MPG  (Read 1193 times)

0 Members and 1 Guest are viewing this topic.

need help with MPG
« on: January 21, 2016, 11:07:27 AM »
Hello all I am a new b and looking for some information. I have an older PC-2-Route Model M2 V1.9 board made by sound logic that I am using to interface with my router. I have look for a manual for this but I guess its to old. It has a 6 pin connection on it for a mpg and i was hoping some one could help me figure out hot to hook it up. The mpg has 5V,0V,A,B, on it ( A&B are square waves output) it also has control for .001 and .010 on it. My questions are how to i figure out how to hook up what wires to the pins and then can i use one of the plug in to run this or will I have to wright my own brain to run it.

here  is a pic of my mpg

O posted this once but not sure if i did it right. trying again.

Thanks for any help Tom

Offline Tweakie.CNC

*
  • *
  •  7,849 7,849
  • Super Kitty
    • View Profile
    • Tweakie.CNC
Re: need help with MPG
« Reply #1 on: January 21, 2016, 11:41:00 AM »
Hi Tom,

Size your picture about 800 pixels wide, click the 'Reply' tab and use Additional Options to post the picture.

Tweakie.


(I have deleted your previous post as multiple posting on the same topic is not beneficial).
Success consists of going from failure to failure without loss of enthusiasm.  Winston Churchill.
Re: need help with MPG
« Reply #2 on: January 21, 2016, 12:52:01 PM »
Ok I will thank you. I want to sure if I posted my first post right. Didn't want to have mutable postings.
Re: need help with MPG
« Reply #3 on: January 21, 2016, 01:50:55 PM »
here is a pic of my mpg