Hello Guest it is October 18, 2019, 10:28:25 AM

Author Topic: MPG motion and following error help needed!  (Read 7591 times)

0 Members and 1 Guest are viewing this topic.

Re: MPG motion and following error help needed!
« Reply #10 on: May 11, 2013, 01:25:46 PM »
My experience has been that I don't use an MPG just yet. Itis on thelistof things to do however.

Mike



Thanks Chaoticone, I did, and finally got a response this afternoon.... (I know I am a little impatient  :P

Hopefully this will be implemented soon.   I still am surprised that no one else has encountered a similar issue?  To all the other DSPMC users, what has been your MPG experience?   

Thanks again.

How do you Zero a tool?  Or zero in on a part?  Or must be a plasma table or something where these do not apply?

I use a Logitech gamepad.  My mill has a powered quill so I can also use the knee to zero out the Z axis manually. Either way works. I have used an MPG on other machines but when I set the machine up originally the MPG was not ready to go IIRC.

Mike
We never have the time or money to do it right the first time, but we somehow manage to do it twice and then spend the money to get it right.
Re: MPG motion and following error help needed!
« Reply #11 on: May 31, 2013, 11:38:48 PM »
the newer firmware does take axis max velocity and acceleration into account with mpg.

rgds
Rufi