Hello Guest it is April 19, 2024, 03:38:17 PM
Profile Guest
« previous next »
Pages: « 1 2   Go Down

Author Topic: Rotary tables and feed rate  (Read 8184 times)

0 Members and 1 Guest are viewing this topic.

Offline Chip

*
  • *
  • 2,055 2,055
  • Gainesville Florida USA
    • View Profile
Re: Rotary tables and feed rate
« Reply #10 on: February 11, 2007, 05:45:19 PM »
Hi, Bathgate

Sent you a PM

Thanks, Chip
Logged

Offline escowizard

*
  • 39 39
    • View Profile
Re: Rotary tables and feed rate
« Reply #11 on: February 11, 2007, 10:25:00 PM »
I find that if I run "constant velocity" on my rotary, it is wicked slow. Maybe you have that checked under "state"

Logged

Offline guynamedbathgate

*
  • 317 317
    • View Profile
Re: Rotary tables and feed rate
« Reply #12 on: February 12, 2007, 05:01:00 PM »
Aha!! I found it.
under-Configure-tool path. theres a little check box that sais "use diameter for feedrate". That did the trick.
one problem down many more still to pop up.
thanks
Logged
Pages: « 1 2   Go Up
« previous next »