Quote from: TOTALLYRC on May 10, 2013, 04:33:49 PM

My experience has been that I don't use an MPG just yet. Itis on thelistof things to do however.

Mike

Quote from: dkyuss on May 10, 2013, 02:36:24 PM

Thanks Chaoticone, I did, and finally got a response this afternoon.... (I know I am a little impatient  ) 

Hopefully this will be implemented soon.   I still am surprised that no one else has encountered a similar issue?  To all the other DSPMC users, what has been your MPG experience?   

Thanks again.

How do you Zero a tool?  Or zero in on a part?  Or must be a plasma table or something where these do not apply?

I use a Logitech gamepad.  My mill has a powered quill so I can also use the knee to zero out the Z axis manually. Either way works. I have used an MPG on other machines but when I set the machine up originally the MPG was not ready to go IIRC.

Mike

the newer firmware does take axis max velocity and acceleration into account with mpg.

rgds
Rufi