Hi Alex thanks for replying to my post. I checked the spindlespeed.m1s micro and found it had a (39) in the first line I removed just the 39 and it fixed the error on line 1 problem, but not the spindle override. I check the wiring on the VFD and it was right so I try to reverse the reference and ground and the VFD would not run that way. so I check to see if there was a setting in the VFD menu and found nothing. so I looked at Mach3 again and under ports and pins there is a setting for the spindle motor for DirlowActive it was checked and i UN checked it and now the spindle override work faster when I slide it up and slower when I slide it down. and when I give it a S command the spindle will change with the command. and runs very close the the speed I give it.
thanks for the help.