Hello Guest it is March 28, 2024, 05:04:31 PM

Author Topic: Re: Newbie with KL-4030 1st time testing problems  (Read 18405 times)

0 Members and 2 Guests are viewing this topic.

Re: Re: Newbie with KL-4030 1st time testing problems
« Reply #40 on: March 29, 2013, 05:28:41 PM »
The only weird thing it is right now that no matter if I press the master switch or leave it unpressed everything works fine. I thought if I release the master switch then nothing will work

Offline Chaoticone

*
  • *
  •  5,624 5,624
  • Precision Chaos
    • View Profile
Re: Newbie with KL-4030 1st time testing problems
« Reply #41 on: March 29, 2013, 05:43:22 PM »
 :)

Do you have to set up the master switch as an estop input?

Brett
;D If you could see the things I have in my head, you would be laughing too. ;D

My guard dog is not what you need to worry about!
Re: Re: Newbie with KL-4030 1st time testing problems
« Reply #42 on: March 29, 2013, 05:50:32 PM »
No. Estop is set up on different input.
Re: Re: Newbie with KL-4030 1st time testing problems
« Reply #43 on: March 29, 2013, 06:06:31 PM »
The C10 I am using came with a very small single strand wire installed as a jumper between the EN and GND terminals. If this connection is open, all outputs should be disabled.

Russ
Re: Re: Newbie with KL-4030 1st time testing problems
« Reply #44 on: March 29, 2013, 06:22:01 PM »
That's where I connect the master switch as per wiring diagram. But when I disconnect it it still moving the motors
Re: Re: Newbie with KL-4030 1st time testing problems
« Reply #45 on: March 29, 2013, 06:48:01 PM »
Remove everything from those 2 terminals and try it.
There could be something goofy with your switch or wiring.
Russ
Re: Re: Newbie with KL-4030 1st time testing problems
« Reply #46 on: March 29, 2013, 06:49:34 PM »
...really, just remove everything from the EN terminal.
There might be something else connected to and relying on the GND terminal.
Re: Re: Newbie with KL-4030 1st time testing problems
« Reply #47 on: April 01, 2013, 07:16:55 AM »
I will try that later after work.