I have a mill setup with Mach and been having a hard time getting it going.
I think we are close but i would like to call someone to go threw a quick trouble shooting. 

 

Sent you a PM

Brett

  Thanks Brett
You got us a lot further along.
We found the wiring wrong on the Z axis servo motor.

It was a great feeling to see  it move.

  Is there a setting in Mach to tell Mach that it is looking at C32 board.
Problem we are having is setting up the steps per inch but when we
give it a move command it goes a totally different distance.

 
There is a complete chapter dedicated to this in the manual.
Mach3 Install & Config. Guide
Up top, under SUPPORT/Documentation

Russ

Good, you will be slinging chips in no time now.   

A couple of these links will help in setting up your steps per and a couple of others that you will want to check right after you get everything moving the proper distance.  Also, the manual Russ is referring too really is a must read for Mach users.  You will be doing yourself a favor to study it front to back.

http://www.machsupport.com/forum/index.php/topic,16315.0.html#new

http://www.machsupport.com/forum/index.php/topic,12512.0.html#new

http://www.machsupport.com/forum/index.php/topic,10308.0.html#new

http://www.machsupport.com/forum/index.php/topic,12513.0.html#new

Brett

  Got it.
This is great.
We are finally getting somewhere.
Thanks