Third party software and hardware support forums. > NC Pod
1 PWM Output for Spindle Speed Control ?
(1/1)
Greolt:
Can anybody tell me if it is planned to implement the PWM output for spindle speed control for the Pod ?
Maybe even go as far as an estimate of when ? ;D
Greg
Greolt:
I think I found my answer. :)
According to the PDF Dave posted, output A is "75khz PWM" for spindle output.
Now I just need to find out if Peter Homan's Digispeed will work with that. :-\
Maybe some VFDs will take that signal direct. ???
Navigation
[0] Message Index
Go to full version