I found a chinese company that offers step motors and drivers, but the page is in chinese, and altavista translator does a so so job.
They have a monster 45Nm stepper motor 6 amps, it says 30-300v, they offer the matching driver. I just want to know if both are compatible with each other and with Mach 3/4.
Im guessing the most common step motor would round the following characteristics:
2 phase
Bi polar
4 leads
1.8º step angle.
And a driver to be compatible with mach 3/4 it has to have TLL inputs and thats it?
I beleive this drive has a +step -step, +direction -direction, +enable -enable. and it has 110v input too.
page is http://www.stepping.cn/
Hope anyone can understand the page.