Hello Guest it is October 18, 2019, 12:36:20 AM

Author Topic: ESS and Mach Lathe, which SW-Version?  (Read 6992 times)

0 Members and 1 Guest are viewing this topic.

Offline TomS

*
  •  17 17
    • View Profile
ESS and Mach Lathe, which SW-Version?
« on: March 09, 2013, 10:50:57 AM »
Hello,
at many posts there are recommended Version 057 for lathe, but this will not with ESS, if i use the ESS, it is nessesary to use upper 062.
What is a good working version with ESS and lathe?
Best regards,
Tom
 

Offline Hood

*
  •  25,855 25,855
  • Carnoustie, Scotland
    • View Profile
Re: ESS and Mach Lathe, which SW-Version?
« Reply #1 on: March 09, 2013, 05:18:49 PM »
I use 057 on the big lathe and it has an ESS, however I use an older plugin for the ESS, 10a I think. If you use one of the newer plugins then you will likely need 062 or newer. I think the problems with Turn started in 066 but cant be sure as I dont think I had anything newer than 057, except my trials of 066/7

Hood

Offline TomS

*
  •  17 17
    • View Profile
Re: ESS and Mach Lathe, which SW-Version?
« Reply #2 on: March 10, 2013, 05:38:55 AM »
Hello Hood,
thanks for your reply. Where i can get this early plugin? On the Warp9 site, there is the earlist Version 10eb1a (and there are big Problems with MPGs)
Best regards,
Tom

Offline Hood

*
  •  25,855 25,855
  • Carnoustie, Scotland
    • View Profile