Hello Guest it is March 28, 2024, 11:25:13 AM

Author Topic: motors not turning  (Read 2417 times)

0 Members and 1 Guest are viewing this topic.

motors not turning
« on: April 14, 2011, 04:10:08 PM »
NEW ON CNC - can  the stepper motors move when you install MACH3 DEMO?
I'm using C35 breakout board,a digital stepping driver and motors KL23H286-20-8b from KELINGINC ELECTRONIC  and I can't make the motor to turn,Help!!
Re: motors not turning
« Reply #1 on: April 14, 2011, 04:38:37 PM »
Does your controller need a specific XML file? My Gecko requires one for it to work.
Re: motors not turning
« Reply #2 on: April 14, 2011, 04:48:37 PM »
Thanks,let me look into?

Offline Tweakie.CNC

*
  • *
  •  9,196 9,196
  • Super Kitty
    • View Profile
Re: motors not turning
« Reply #3 on: April 15, 2011, 02:28:52 AM »
Hi Raul,

Welcome to the forum.

The Mach3 demo version will work just fine.

Your C35 requires an enable signal to get any output - check that the EN terminal is connected to +5Volts.

Hope this helps.

Tweakie.
PEACE