Hello Guest it is December 06, 2021, 06:35:36 AM

Author Topic: Precix Retrofit Advice  (Read 1640 times)

0 Members and 1 Guest are viewing this topic.

Precix Retrofit Advice
« on: November 21, 2012, 07:47:01 AM »
Apologies in advance if this is posted under the wrong board, couldn't figure out where it fit best.

I have a 2-3 year old 5' x 10' Precix Servo-based (Delta) CNC-Router and am heavily considering replacing the controller.  Considering Mach3 as the base platform, any recommendations on quality drive interfaces and motion controllers?  This is not a commercial machine, but is used heavily, so reliability and precision is important.